intake manifold

An Analysis and Application of Negative Pressure of Engine Intake Manifold

发动机进气管负压的分析与应用

The result of experiment shows that: ( 1) The intake manifold temperature drops from 160 ℃ to 55 ℃ by change water jacket aftercooler into a new designed air to air aftercooler and have a great NOx reduction.

试验结果显示：（1）通过重新设计制造的空气-空气中冷器替代原水套中冷器，额定点进气温度从106℃降低到55℃，额定点NOX的浓度大幅下降。

Remove intake manifold bolts.

拆下进气歧管螺栓.

In the roundpiston VV carburetor, the piston is moved by intake-manifold vacuum.

在圆形活塞的VV化油器中, 活塞是由进气歧管真空移动的.

The simulation was studied under different injection parameters with varying intake manifold wall setup and intake air conditions.

模拟过程中，分别就不同喷射参数、进气道壁面条件以及进气条件展开对比研究。

If the engine backfires , the sudden pressure in the intake manifold forces the valve back.

如果发动机回火, 进气歧管骤增的压力就迫使阀门向后移动.

Clip in wire harness on the intake manifold and push in retaining clip for wire harness on the intake manifold.

卡入进气管上的线束并将线束固定卡子按到进气管上。

Vibration Test Failure Analysis on Engine Plastic Intake Manifold and Improvement Study

发动机塑料进气歧管振动试验失效分析与改进研究

The intake manifold pressure is lower when the cranking speed increases, thus the fuel metering strategy should be modified.

随着拖动转速升高，进气歧管压力降低，对应的喷油策略也应随之调整；

The main difference is how they move air to the intake manifold of the engine.

这三种形式主要的不同在于它们把空气引入吸气导管的方式.

Install the intake manifold ( refer to Group 11 , Exhaust System and Intake Manifold ).

安装进气歧管 ( 见单元11-排气系统和进气歧管 ).

The pudding results from the failure of all the fuel to vaporize and from the sorting effect of the intake manifold.

积洼是全部燃料蒸发得不充分和进气歧管类似影响的结果。

During the developing process of one V-6 type engine intake manifold with 319.0 alloy, many defects as shrinkage and pin hole occurred frequently, which hindered its normal supply and thus affected the OEMs productivity.

国内某款乘用车V型6缸发动机进气歧管（319.0）开发过程中，屡屡出现缩孔、气（针）孔等铸造缺陷，严重地影响了供应商的正常供货以及整车厂产能的提升。

The flow characteristic of intake manifold has sensitively influence on engine, including economy performance, dynamical performance and the level of injurant emission.

其流动特性对发动机性能的影响十分敏感，其优劣影响到汽车的经济性、动力性和有害物排放的水平。

Degrease intake manifold flange on the hot-film mass air flow sensors and inner intake manifold.

除去热膜式空气质量流量传感器上的进气管法兰以及内部进气管上的润滑脂。

When there is vacuum in the intake manifold, the vacuum holds the diaphragm up.

当进气歧管有真空存在时, 真空便向上吸引膜片.

This device, called the manifold heat-control valve, is built into the exhaust and intake manifold.

这种装置称为“歧管热控制阀”, 它拼装在排气与进气歧管中.

Remove the intake manifold ( refer to Group 11 , Exhaust System and Intake Manifold ).

拆下进气歧管 ( 见单元11-排气系统和进气歧管 ).

Design of intake manifold and experimental study for pressure wave supercharged diesel engines

气波增压柴油机进气管设计与试验研究

A few percent of the CO2 molecules in the air manage to find such electrons. When there is vacuum in the intake manifold, the vacuum holds the diaphragm up.

空气中的一部分co2分子会吸引那些自由电子。当进气歧管有真空存在时，真空便向上吸引膜片。

Remove intake manifold, yoke retainer and aligning yokes.

拆下进气歧管 、 叉臂轭护圈,并对正叉臂轭.

Direct gasoline injection and hydrogen intake manifold supply.

直喷式汽油和氢气进气歧管供应.

At present, the gasoline engine plastic intake manifold design technology is mature. The domestic could conduct independent research and development ( R& D).

目前，汽油机塑料进气歧管的设计技术上已经成熟，国内已经可以自主研发并进行大批量生产，而柴油机塑料进气歧管的设计还处于起步阶段。

Ultrasonic welding machine can attain to bonding automotive parts, such as intake manifold, instrument panels, tail lights and bumpers, etc.

臻能超声波焊接机可接合汽车部件，例如进气歧管、仪表板、尾灯及保险杠等；

Fault Description ( reason ): High voltage detected at intake manifold pressure sensor signal pin.

故障描述 ( 原因 ): 检测到进气歧管压力传感器信号电压值高.

This vacuum, called intake-manifold vacuum, varies as the operating conditions change.

这个真空叫做进气歧管真空.这种进气歧管真空随运转情况而变化.

We specialize in making plastic air intake manifold . Welcome contact me for more information!

我们公司专业生产塑料进气歧管, 欢迎有需要的福友与我联系!

Relation between Startability and Remaining Gasoline in the Intake Manifold

进气岐管内残留汽油和起动性的关系

The result shows that the time constant of the intake manifold is a function of engine rotate speed and throttle opening, and the more the throttle opening, the smaller the time constant.

结果表明，进气管时间常数是发动机转速和节气门开度的函数，节气门开度越大，时间常数越小。